SONY
TC-880-2
Recorder-Reproducer
A professional half-track tape deck with 10.5 inch reel capacity and 15 in-per-second tape speed providing unsurpassed recording excellence and versatility.
Direct-Drive Servo-Control System
One capstan is an extension of the servo-control motor; the other capstan is connected to it through a belt-driven inertia-flywheel. The result is a mechanically-simple, closed-loop, dual-capstan, tape-drive that reduces Wow and Flutter to 0.02%.
Phase Compensator Circuit
Phase variations from the original source are a natural function of the recording process, producing varying levels of harmonic distortion. During playback, Sony's exclusive Phase-Compensator-Circuit corrects these phase variations, resulting in recordings virtually identical to the original source.
Peak Reading VU Meters
Calibrated to NAB standards, these meters provide instantaneous electronic measurement of peaks up to +15 dB. 3-way versatility: Standard VU operation,
Peak-Reading display of transient peaks only,
Peak-Hold display with hold of transient peaks.
Syncro-Trak
The record head doubles as a playback head for creating perfectly synchronized multitrack recordings. When adding a second track of sound, simply monitor the first track through the record head to eliminate a time delay. Punch-In Record lets you go into the record mode instantly, without stopping the tape.
Stepped Record and Playback Attenuators
Each detent equals 2dB, readable on the meters.
Discrete FET Record/Play Preamps
Rich, warm, transparent sound.
4-Digit Minute/Second Counter
Reads actual elapsed time at 15 ips;
for 7.5 ips, multiply by 2.
4-Head Plug-in Headblock
Enables playback of both 2-trk
& ¼-trk tapes at flip of a switch.
Balanced XLR Microphone Inputs.
3-position Equalization Selector switch.
2-position Bias Selector switch.
Logic-controlled transport.
Variable-speed Pitch-control.
Discrete FET electronics.
Remote-control capability.
Headphone Volume-control.
Plug-in Headblock Assembly.
3-position Microphone Pad.
Non-magnetizing Record-head.
Vibration-free capstan motor.
Sound-On-Sound & Echo capability.
Automatic Shut-Off.
Scrape-flutter Filter.
Automatic tape-lifters.
Mic/Line mixing.
Ultra-High-Frequency Bias.
Operates in any position.
Plug-in power cord.
Walnut side panels.
Flush-mount carrying handles.
Tape Speeds:
15 & 7.5 ips
Reel Size:
Up to 10.5-in
Rewind & Fast-Forward:
150 seconds for 2400 ft
Frequency Response:
Standard tape:
25~30k Hz ±2 dB at 15 ips
25~20k Hz ±2 dB at 7.5 ips
SLH-180 tape:
20~45k Hz ± 2 dB at 15 ips
25~25k Hz ± 2 dB at 7.5 ips
FeCr tape:
20~47k Hz ± 2 dB at 15 ips
Signal-to-Noise Ratio:
Standard tape: 59 dB
SLH-180 tape: 62 dB
FeCr tape: 65 dB
Wow & Flutter (rms/nab):
0.02% at 15 ips
0.03% at 7.5 ips
Line Inputs:
Plug Type: RCA
Impedance: 100k Ohms
Sensitivity: 0.06 Volts
Microphone Inputs:
XLR-Balanced on back panel
¼"-phone on front panel
Sensitivity: -72 dB
Bias Frequency:
160k Hz
Meters:
Instantaneous Peak-reading
VU meters with Hold function
Four Heads are better than three:
2-track Erase
2-trk Record
2-track Play
¼-track Play
Motors:
Direct-Drive AC-Servo motor for main capstan.
Outer-Rotor Enertia-Flywheel for secondary capstan.
Induction reel motors.
Line Out:
Plug Type: RCA
Minimum Load Z: 10k Ohms
Level: 0.435 V at 0 VU with 100kΩ load
Headphone Out:
Plug Type: ¼-inch phone jack
Minimum Load Z: 8 Ohms
Power Requirements:
120vac, 135w, 60hz
Plug-in power cord
Dimentions:
18.4"w, 20.3"h, 10.5"d
Net Weight:
80 lbs / 36 kg
AllegroSound
− Established 1973 −
"love what you listen with"
Los Angeles, California USA
Rick@AllegroSound.com
FOR SALE - TRADE 
HOME / Master-Index 
* AllegroSound et al assumes no responsibility for the use or misuse of products, services, info, etc.
website design & original content ©AllegroSound, Los Angeles USA. All rights reserved.